Ventilator Assignment Use the Micro Bit and the Inventor's Kit to build a fan circuit. This circuit serves as radio receiver, and a second Micro Bit as radio transmitter. If the button at the receiver is pressed, the fan of the receiver circuit is switched on. Additionally, the follow-up time [...]

LED dimming Assignment Use the Micro Bit and the Inventor's Kit to program a LED with brightness adjustment via the potentiometer. Use the Analog Digital Converter (ADC) at the pin of the potentiometer and Pulse Width Modulation (PWM) for the LED. If you need any help, take a look into [...]

Light sensor Assignment Use the Micro Bit and the Inventor's Kit to program a streetlamp. If the ambient brightness drops below a specific value, the LED starts flashing. If you need any help, take a look into the worksheet or watch the tutorials. Blockcode [...]

Flashing LED Assignment Use the Micro Bit and the Inventor's Kit to program a LED flashing once per second. To do so, use the pinboard, a green LED, a suitable series resistor and 2 jumper cables. If you need any help, take a look into the worksheet or follow the [...]

Traffic light circuit Assignment Use the Micro Bit and the Inventor's Kit to program an event-controlled traffic light. This means, the traffic light usually always "remains" green for cars. If the button is pressed, the traffic light flashes 4x green and is then switched from yellow to red. After a [...]

Servo Task Write a program with which you can control the angular positions of a servo (or servo arm) with the help of the Inventor's Kit. Extend the task according to your individual wishes (e.g. use a cardboard pointer to display temperature, direction, inclination, etc.). If you need help, take [...]